Articles

How-To Setup, Bind and Trim the Blade mSR BNF

9/25/2009 by Jim Booker

Copyright:© 2009 Horizon Hobby, Inc.

Print This Article Bookmark This Article
Share This Article

A short course - How to Bind and Trim Your mSR Heli

The new E-flite mSR ultra micro helicopter is truly something different and exciting for RC hobbyists.  It is a hot rod for sure, but actually the flight characteristics make it pretty easy for most people to learn to fly in short order. However, the first experience with this little heli can be a bit surprising if you are not prepared for it. There are some simple steps to take when you get ready to fly it.  Many people are considering the BNF version, and I have heard some people asking how difficult it is to bind and set up in their DSM2 transmitter. The settings are easy and straightforward. Follow along and we will show you how.

Our video is going to emphasize three bullet points:

  • Bind-N-Fly transmitter settings – first thing to do
  • Bind the mSR to your DSM2 transmitter – very easy
  • Trim the heli out before the first flight – this is fun

At this point your heli is ready for high-performance action.  Take it easy until you are familiar with the control response—this little heli is quick to respond, but having the trims set up makes it very easy to progress without running into anything in the living room.

If you don’t have an mSR, get one now. You are going to have a lot of fun with
this one!